Steps to making Embroidered Iron on Patches

 

There was a point in time when embroidered iron on patches were used to mainly conceal holes which might have transpired on a garment. However with a modest amount of versatility and creative thinking you can make use of this patch and include an element of spunk and flair to any clothing which you opt for. It’s not just clothes on which you can use these patches but these embroidered iron on patches may be used to decorate bags, shoes, pillows, furniture, hat’s�the list is just as infinite as your imagination.

In order to create personalized patches then you can easily do it yourself. You could get most of the materials that you will need easily at stores where you can get pre-made patches. The most significant selling point of utilising an iron on patch is you can spend all the time you need to in making them but ought to spend not much time affixing them.

You will have to have your materials set up before you begin making your patch. But before you get your resources think about the style of the patch that you’d like to make. Upon getting the design made to size you must sketch or trace precisely the same onto the cloth. Make certain you don’t embroider the design and style on the cloth without having the hoop so that the executed pattern comes out flat. Now place a tear away backing sheet on the wrong side of the patch and connect the embroidery hoop in place in order that the design is taut. You may even use some backing spray to fix your backing paper in position.

 

You can now begin embroidering your iron on patch. Ensure that your thread isn’t longer than two feet at some point so that you can embroider readily and don’t have to bother with unnecessary tangles and knots. Now embroider across the design making sure that you start out each length of the thread from the back of the pattern in order that the knots or extra lengths don’t show up in the front of the design.
Once you’ve completed embroidering your patch take it out of the hoop and take off the backing paper by tearing it off lightly. Try taking some iron on adhesive paper and cut it to the similar size of your patch. Now put your patch with their face down upon an ironing board and put the iron on sticky patch glue side down on your patch. Have a clear section of cloth or paper towel over the sheet. Set your iron on the low configuration and iron the adhesive to the patch. You may even use the silk setting in your iron. The paper towel or rag will ensure that none of the glue gets attached to your iron.

Your embroidered iron on patches is going to be available to make use of as soon as you complete this step. Now all you need to do is peel the paper backing the adhesive behind the patch, place it where you would like to place it and iron it tightly in place. Iron the cloth back to front so that the adhesive gets properly activated and keeps the patch in place.